EWI perimeter+sub-floor insulation with controlled ventilation

Detail for insulation to a ground floor and sub-floor, where the existing internal ground floor void is inaccessible, or it is not possible to lift the whole floor.

To allow the existing ground floor finish to be retained: a granular insulation infill is proposed to prevent heat loss through the floor, with perimeter insulation to footings, used to to prevent cold bridging through the external wall, and the ingress of damp and mould.

The sub-floor ventilation is used to ensure a reduced risk of condensation and humidity build up within the void, using a small humidity controlled fan. (This system can also be modified with temperature and humidity monitoring systems below the floor; as well as additional personal controls for the ventilation fan.)

View detail →

EWI Perimeter insulation to footings

Perimeter insulation detail for external wall insulation down to below ground level. Detail for junction between EWI and XPS perimeter insulation for below ground use, providing 600mm maximum insulation below the depth of the internal floor level.

View detail →

EWI Plinth Insulation to below ground

Detail for an external wall insulation plinth detail to just below ground level. Intended to ensure water-tightness and prevent thermal bridging to zones under an existing floor by providing continuous insulation down to ground level.

Woodfibre EWI to stop a minimum of 300mm from the external ground level, with XPS insulation fixed using adhesive bond to carry down to below ground level, a minimum 300mm below the internal floor level of the building.

Target Values: 0.2 W/m2K for whole construction.

View detail →

EWI to just below ground with plinth and ventilation detail

Detail for external wall insulation to below ground floor level, with a periscopic vent and air-brick installed through EWI to ventilate a basement or cellar. Required where existing air-bricks to a sub-floor space/void would be blocked by the installation of External or Internal wall insulation. Periscopic vents should ensure continued clear air-path to sub-floor, to ensure adequate ventilation.

View detail →

EWI Recessed Plinth to just below ground

Detail for external wall insulation plinth to ground, where the internal floor of the building to be retrofitted is solid beneath the internal finished floor level. EWI is carried down to 300mm minimum below internal floor level to prevent cold bridging, but stopped short of external ground level.

View detail →